Instruction

Mark the height

A TexRacks with 40 shelves must be at least 178 cm / 70" from the floor.
With 20 shelves, 92 cm / 36" is sufficient.

Attach the paper template

Attach the paper template at the correct height and absolutely horizontally using a spirit level. Secure the template to the wall with adhesive tape.

Mark the drilling points

Press the marking points on all 6 drill holes with a screwdriver through
the template, making a small mark in the wall.

Drill the holes

Drill all 6 holes to attach the metal supports

 

Choose the wall anchors

Choose the right wall anchor for wooden or stone walls.
Drywall anchor 1 is for wooden or drywall.
Masonry anchor 2 is for stone walls.

 

Insert the wall anchors

Insert all 6 wall anchors into the 6 wholes

 

Fastening the metal supports

Screw both metal supports to the wall with 3 screws each

Metal supports finished

This is what your two metal supports on the wall should look like now

 

Slide the crossbeam into the fabric shelf

Push both metal crossbeam through the holes in the fabric shelf so that
they protrude a few millimeters on the other side

 

Place the fabric shelf on the metal supports

Lift the fabric shelf and place it on the metal supports so that the small
pins fit into the holes in the crossbeams.You may need a second person
to help you with this process.

Insert the shelves

Insert the shelves into the fabric shelf.
Now you're done, and you can properly store your valuable die-cast models.